If you are using 2 camera in the network and you want to access the camera remotely via solo link, Here is the thing you need to do:
 
  • Configure the 1st camera with same wireless settings from the router with the follwing: �
    • Same Wireless setting should be setup to the WVC54G
    • IP Address of 192.168.1.116
    • Default Gateway: 192.168.1.1
    • Subnet Mask: 255.255.255.0
    • DNS: Valid DNS from the Status page of your Router
    • Go to Options Tab and select UPNP Enable
    • Enable Alternate port and change the port to (1025-65534) which should be unique from any devices used.
    • Go to the linksys router setup page
    • Enable port forwarding for port 1025 into an ip address of 192.168.1.116
    • Then Go to the Solo Link DDNS Tab of the Camera
    • Input the username and password needed
    • Change the WAN port to 1025
    • DDNS update should be Every 15 min
    • Make sure that the Status of the DDNS should state Registered and Connected
  • By then you should be able to access your camera via Domain Name through the following pattern (cameraname.DNS you registered.ourlinksys.com )

With regards to the second WVC Camera

  • Configure the 1st camera with same wireless settings from the router with the follwing:  
    • Same Wireless setting should be setup to the WVC54G
    • IP Address of 192.168.1.115
    • Default Gateway: 192.168.1.1
    • Subnet Mask: 255.255.255.0
    • DNS: Valid DNS from the Status page of your Router
    • Go to Options Tab and select UPNP Enable
    • Enable Alternate port and change the port to (1024) which should be unique from any devices used.
    • Go to the linksys router setup page
    • Enable port forwarding for port 1025 into an ip address of 192.168.1.115
    • Then Go to the Solo Link DDNS Tab of the Camera
    • Input the username and password needed
    • Change the WAN port to 1024
    • DDNS update should be Every 15 min
    • Make sure that the Status of the DDNS should state Registered and Connected
  • By then you should be able to access your camera via Domain Name through the following pattern (cameraname.DNS you registered.ourlinksys.com )